Set NORMAL_SCAN_REQ on SELECT_NETWORK/ENABLE_NETWORK

wpa_s->scan_req needs to be set in these cases to get correct scanning
behavior. This is mainly needed for starting of AP mode operation
immediately in ap_scan=2 case.

This fixes an issue that was found with mac80211_hwsim test cases in the
following sequence: dbus_autoscan dbus_ap_scan_2_ap_mode_scan

Signed-off-by: Jouni Malinen <j@w1.fi>

wpa_supplicant/wpa_supplicant.c

@@ -2581,8 +2581,10 @@ void wpa_supplicant_enable_network(struct wpa_supplicant *wpa_s,
 			wpa_supplicant_cancel_sched_scan(wpa_s);
 		}
 
-		if (wpa_supplicant_fast_associate(wpa_s) != 1)
+		if (wpa_supplicant_fast_associate(wpa_s) != 1) {
+			wpa_s->scan_req = NORMAL_SCAN_REQ;
 			wpa_supplicant_req_scan(wpa_s, 0, 0);
+		}
 	}
 }
 
@@ -2710,8 +2712,10 @@ void wpa_supplicant_select_network(struct wpa_supplicant *wpa_s,
 	wpa_s->reassociate = 1;
 
 	if (wpa_s->connect_without_scan ||
-	    wpa_supplicant_fast_associate(wpa_s) != 1)
+	    wpa_supplicant_fast_associate(wpa_s) != 1) {
+		wpa_s->scan_req = NORMAL_SCAN_REQ;
 		wpa_supplicant_req_scan(wpa_s, 0, disconnected ? 100000 : 0);
+	}
 
 	if (ssid)
 		wpas_notify_network_selected(wpa_s, ssid);